{"id":1193,"date":"2009-06-09T20:40:55","date_gmt":"2009-06-09T20:40:55","guid":{"rendered":"https:\/\/www.diaryofanadi.co.uk\/?p=1193"},"modified":"2022-11-05T18:29:17","modified_gmt":"2022-11-05T18:29:17","slug":"kneeling-chair-project-3-update","status":"publish","type":"post","link":"https:\/\/diaryofanadi.co.uk\/?p=1193","title":{"rendered":"Kneeling Chair Project #3 (update)"},"content":{"rendered":"

I’m putting the parts together at the moment – just finished the seating half.<\/p>\n

While I was assembling it I discovered an error in one of the dimensions on the diagram in Part 2<\/a> of this project.<\/p>\n

You can find Part #4 (the final) of this project here<\/a>.<\/p>\n

The support strut longest length should be 90mm and not 110mm.<\/span><\/strong><\/p>\n

I’ve amended the original diagram and annotated the Part 2 write up. Apologies to anyone who has been following this (and there appear to be quite a few) – but at least it is an error in the right direction – the part will just need trimming slightly. I used a flap wheel on my angle grinder to work it down.<\/p>\n

I don’t know how it happened. I made a mock-up out of paper when I did the original calculation, so I can only guess that I put the wrong dimension in the drawing as a typo – and that’s what I was following!<\/p>\n

Incidentally, I’m getting better at welding as I do this and one thing I’ve learned – probably obvious to those with more experience – and that is GO SLOWLY<\/strong> . You get a nice weld without gaps or pockets of slag.<\/p>\n

EDIT:<\/strong> If you came to this page from a search engine, don’t forget to look for Kneeling Chair Project parts #1,\u00a0#2, #3, and #4 (plus a couple of updates) using the site search facility. This project is now complete and there are drawing\/blueprints in the other parts.<\/p>\n